If your paddle ceiling devotee's lights no thirster work, the culprit is unremarkably the draw in-chain light throw mounted on the bottom of the fan.
Present's how to test and replace the trade.
To limit if the pull mountain chain switching is defective:
-
- Put off the mogul to the buff at the circuit breaker.
-
- Get rid of the traverse plate connected the bottom of the fan.
-
- Disconnect the wires coming from the switch to the lights.
-
- Realize sure the wires are non affecting anything, then turn the power back off on at the breaker.
-
- Check the switch wires with a electromotive force tester to see if power is coming from the switch to the lights.
-
- If electricity is present below the switch, the problem is either in the wires going to the light, the bulb sockets, or the light bulbs.
-
- If electricity is not present below the shift, turn the power to the devotee back up.
-
- Disconnect the wires future day into the switch from the fan.
-
- Make a point the wires are not touching anything, then turn the exponent support on at the breaker.
-
- Check the wires advent into the switch from the fan with a voltage tester to see if power is coming from the fan to the switch.
-
- If electricity is non coming from the fan to the shift, the trouble is with the fan wiring rather than the permutation.
-
- If electrical energy is coming from the winnow to the switch, the trouble is with the pull chain of mountains switch.
- If the switching is the job, remove the switch, supplant it with a new switch, reattach the wires, turn the power back happening, and pull the chain on the switch to learn if the lights work.
Watch this video to find dead more.
Foster Information
- How to Replace a Paddle Ceiling Fan Deplumate Chain Exchange (article)
- How to Stop Wobble and Vibration in a Dabble Ceiling Buff (article)
- How to Repair an Out of Balance Cap Fan (video)
- How to Control a Cap Fan Without a Wall Switch (article)
- How to Install a Paddle Ceiling Fan (video)
Telecasting TRANSCRIPT
Danny Lipford: Recently a homeowner asked me if their ceiling fan light kit could embody repaired without replacing the whole thing. If the fan still works advisable, it's worth looking into the light kit.
If thither are no loose wires visible, the culprit is likely a faulty pull chain switch. To check, turn off the power at the surf box, and disconnect the wires coming from the switch to the lights. Be sure that the wires are not affecting anything before you turn the power back on, and test the wires with a voltmeter.
If none voltage is attendant, turn the power back up, and disconnection the wires orgasm into the switch from the fan. Again, be sure no wires are moving anything before turning on the index to test them with the meter.
If voltage is present above the switch, but not below it, then the switch is bad. A replacement displume chain alternate is only a couple of dollars and should screw into exactly the similar location Eastern Samoa the gray-haired combined.
With the power off, connect one side of the transposition to the wires coming in from the sports fan, and the other side to the wires feeding the lights.
Remote Control Ceiling Fan That Works With 3-way Switches With Two-wire Up at the Light
Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/